Beware of eight hidden dangers of poor decoration

  • Detail

1、 The wall surface is slotted and the wall is cracked

the buried pipeline must be slotted on the wall and the ground before the pipeline can be buried. A few workers carried out brutal construction during the slotting operation, which not only damaged the load-bearing structure of the building, but also may cause damage to other nearby pipelines

reminder: before construction, confirm the direction and location of the pipeline with the construction team leader again. For different wall structures, the requirements for slotting are also different: the load-bearing wall in the house is not allowed to be slotted, and the wall with insulation layer is easy to cause cracking on the surface after slotting, while the slotting on the ground should be careful not to damage the floor, causing trouble to the downstairs residents

II. Hidden dangers of electric wire threading

in the construction of home decoration, almost all wires are threaded in PVC pipes and buried in the wall. If the workers are not careful in operation, the wires will be twisted in the pipe, causing hidden dangers of electricity. If workers deliberately cut corners, they will use wires with connectors or put several wires in the same PVC pipe.

reminder: consumers had better buy Wires by themselves, and then supervise the workers' operation on site. After installation, they should conduct power on inspection, and let the decoration company leave a pipeline diagram. When the electrician just buries the wires into the wall, he can number these walls and draw a plan, then draw the direction and specific position of the wires with a pen, indicating the direction from the floor above, from the ground below and adjacent to the wall, especially the joint position of the pipeline, so that once there is a fault, the line position can be found immediately.

III. The electric wire installation socket is hot

the electrician does not wire according to the construction requirements when installing sockets, switches and lamps. Especially when consumers use some water heaters, air conditioners and other electrical appliances with large power consumption, switches and sockets are heated and even burned, which brings great losses to consumers.

reminder: during construction, supervise electricians to carry out construction in strict accordance with the operating procedures. After all switches and sockets are installed, be sure to check whether these parts have heating.

IV. laying problem tiles falling off

laying wall and floor tiles is a highly technical process. If you cut corners, you are most likely to have problems such as hollowing of ceramic tiles. The cement and adhesive used for paving ceramic tiles are also exquisite. If the proportion is unreasonable, there will also be problems such as falling off

reminder: the quality acceptance standard for family room decoration engineering requires that the paving of wall and floor tiles should be flat and firm, with clear patterns, no dirt and mortar marks, the surface color is basically the same, the joints are uniform, the plates are free of cracks, corners and missing edges, and the local hollowing should not exceed 5% of the total




Copyright © 2011 JIN SHI